top of page

CVOA Midwest Region

Public·14 members

CV #0803 Dyno Sheet

Hello,

I know posted the run of CV #0803 on Facebook, but here is the actual Dyno Sheet. The RPM gauge was not hooked up to the car from the dyno computer, but at 100 mph the car was at 7000 rpm in 4th gear. (As you all know, you can actually gage the RPMs by the Speedometer because the two are almost identical in where the needle points! 153 HP at the rear wheels is pretty good, and JC is pretty happy with it. We were hoping for closer to 165 at the rear wheels, to be honest though.

thanks,

John J. Cowall


41 Views

2.3L crank with cylinders bored .060 over. High compression pistons, estimate at 12 to 1 compression. Head has been heavily ported, decked .030. Has Crane 430 lift cams. Running 45 mm webers. A pretty stout little motor.

About

Interact and exchange ideas with members of your region or a...

bottom of page