Hello Ladies and Gentlemen,

I just found a replacement source for the Neoprene Rear Main seal that the Club is currently out of stock on.

Felpro BS 13241 (and Mahle JV728) are both out of stock. No ETA at this time when stock will be available again. (According to Amazon Prime or Summit, both say Mid February for the Felpro to be in stock, but not a for sure )

But

Enginetech SO629 is in stock! On Amazon Prime for about $28.00 per piece. Showing 8 left in stock.

If you are planning on re-assembling a CV engine in the near future, better get these before they sell out!

(There is a Felpro BS 40183 that is for a Jeep that fits the groove, but you would need to trim the seal itself down. Has a metal rod in it, and you would need to cut the rod. Theoretically, this part would work once trimmed. But, it has not been tested on a CV as of yet. This was rumored to fit the groove of the block, which it does, but the ends stick out, which means trimming. So, I recommend getting the Enginetech source one before going to this option.)

thanks,

John J. Cowall