Hey everyone, well it's finally cooled off here in Scottsdale so my idle projects are now underway again.

I am trying to replicate the muffler and tail pipe configuration on #0549. The exhaust is factory and intact to the muffler. I understand based on the tail pipe upper hanger it was a dual output from the muffler. Is there a aftermarket muffler that would be a good start (1 in 2 out)? Does anyon have a picture or a web link to a picture of how the 2 tailpipes are bent?

2nd question, I have begun the horrible task of removing the "Zeibart" undercoating from the car. I have found a combination of 3M adhesive remover, Purple Power, Goo Gone and a steam cleaner seem to clean the coating off the sheetmetal. Was the florepan painted gray over red oxide primer? (see picture) Thanks Eric